The welding robot has short response time and rapid action, and the welding speed is 60-120cm/min. This speed is much higher than manual welding (40~60cm/min). The robot does not learn or rest during operation, but it is impossible for workers to stop without rest when they go to work. At the same time, the work efficiency of workers is also affected. Affected by factors such as clear mind, workers will ask for leave, daze, chat, and pay overtime for overtime. The robot does not have the above problems. As long as the external water and electrical conditions are ensured, the welding robot can continue to work and the welding robot has stable performance. It can be trouble-free for 10 years, which virtually improves the production efficiency of the enterprise.
With the development of science and technology, traditional welding technology is gradually replaced by welding robots. The dirty, messy, and poor welding environment makes many workers unwilling to stay in this environment. So what is the comparison between traditional manual welding and automated welding robots? Next, the editor brought a detailed introduction, so come and watch.
The welding robot connecting plate is a commonly used part of construction cranes, which is mainly composed of a bottom plate and four pins. The pin and the bottom plate are fixed by circular fillet welding. The previous welding method uses manual CO2 gas shielded flux-cored wire welding technology. Because the weld is a circular fillet weld, the connecting plate is commonly used in construction cranes. Components, mainly composed of a bottom plate and four pins. The pin and the bottom plate are fixed by circular fillet welding. The previous welding method uses manual CO2 gas shielded plus flux cored wire welding process. Since the weld is circular fillet weld, it is easy to cause the appearance of the weld when manual operation Poor quality, low welding efficiency, poor bonding between the loop line of the weld and the loop line of the welded part, and other shortcomings, which are likely to cause "desoldering". At the same time, in order to ensure the appearance quality of the weld, a grinder is required to polish the weld after welding. It is easy to cause increase in welding cost.
The comparison between traditional welding technology and automated welding technology is introduced. Through the analysis of the above article, automated welding robots have unparalleled advantages. The use of robots for welding ensures that the quality of the products produced is effective and unified, and it also makes people from the harsh I was liberated from the environment, thank you for reading.
